Inspired by Alice

Designer Jamie Hogsett
Skill Level Intermediate
Click to print instructions

Materials

21x24mm Shibuichi Heart Key Toggle Clasp from Green Girl Studios – 1 set
2mm x 2mm Gold Filled Crimp Tubes - 4 pcs
3mm Gold Filled Crimp Covers - 4 pcs
4.5mm Gold Filled Jump Rings - 5 pcs
12x18-17x21mm assorted Shibuichi Charms - 5 pcs
4x26mm Pink Center-Drilled Stick Pearls - 12 pcs
6x7mm Gray Pearls - 26 pcs
6mm Mint Green Czech Glass Swirled Rounds - 14 pcs
4mm Crystal Golden Shadow Crystallized Swarovski Elements Crystal Rounds - 8 pcs

Tools

Chain Nose Pliers
Flat Nose Pliers
Cutters
Crimping Pliers
Bead Stoppers

Instructions

Finished Size: 18"

Step 1: Attach 1 jump ring to each charm. Set aside.

Step 2: Cut 24" of 24K Gold wire. Cut 17" of 925 Silver wire. Cut 17" of Champagne wire.

Step 3: Use the 24K Gold wire to string 1 crimp tube and the ring/heart half of the toggle clasp. Pass back through the tube and crimp. Cover the crimp tube with a crimp cover.



Step 4: String 3 gray pearls, 1 crystal round, 1 gray pearl, 1 glass round, 1 gray pearl, 1 crystal round, 3 gray pearls, 1 crystal round, 1 gray pearl, 1 glass round, 1 gray pearl, 1 crystal round, 3 gray pearls, and 1 crimp tube.

Step 5: Pass the very ends of the 925 Silver and Champagne wires into the crimp tube. Snug the beads on the 24K Gold wire, and crimp. Cover the crimp tube with a crimp cover.

Step 6: Use all three wires to string 1 glass round, 1 jump ring (attached to 1 charm), and 1 glass round.

Step 7: Use the 24K Gold wire to string 3 pink pearls. Place a Bead Stopper at the end of the 24K Gold wire. Holding all three wires, with the 24K Gold wire in the center, braid the wires together. *When the 24K Gold wire returns to the middle, slide 1 pink pearl up into the braid. Repeat from * twice.



Step 8: Repeat Steps 6 and 7 three times. Repeat Step 6. Use all three wires to string 1 crimp tube. Snug the beads on the wire, and crimp. Cover the crimp tube with a crimp cover. Trim the 925 Silver and Champagne wires. Do not cut the 24K Gold wire.



Step 9: Use the 24K Gold wire to Repeat Step 4. String the bar/key half of the toggle clasp. Pass back through the tube, leaving a loop of wire large enough to allow the bar/key half of the clasp to fit into the ring/heart half of the clasp, and crimp. Cover the crimp tube with a crimp cover.



Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is
given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction
of this project as a result of improper safety precautions.