Holiday Wire Snowman Ornament
Designer Sara Oehler

Materials

18ga Soft Flex Craft Wire -15"
28ga Soft Flex Craft Wire - 8"
Ribbon - 6"

Tools

WigJig Olympus-Lite
WigJig Olympus Deluxe Super Pegs
Nylon Jaw Pliers
Cutters
Round Nose Pliers
Chain Nose Pliers

Instructions



Step 1:
First, I like to run my nylon jaw pliers over the craft wire to start working the wire to make it more stiff but also to get rid of any bends or kinks as it comes off of the spool. Place the pegs in your WigJig as shown above. Using 15 inches of 18g craft wire, make a loop with round nose pliers. Place the loop on a small metal peg. Guide the wire around the super peg as you spin the WigJig. When you turn the jig and guide the wire, the jig will make lovely and fluid lines that can be repeated time and time again. Continue winding the wire around the pegs until you complete the snowman shape.











Step 2:
Pop the design off of the pegs. It will look a little wonky.



Step 3: Using 8 inches of 28g craft wire, wrap the bottom and middle circles together to create the bottom of the snowman.



Step 4:
Using 8 inches of 28g craft wire, wrap the top and middle circles together to create the top of the snowman.



Step 5:
Using chain nose pliers, tuck the excess 18g wire behind the wire wrapping.



Step 6:
Trim the 18g wire and wrap using the 28g wire a few more times. Twist the two ends of the 28g wire on top and bottom, trim excess wire.



Step 7:
Using 6 inches of ribbon, tie a single knot between the top and middle circles to create a scarf. Trim for the best look.


Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.