Knitted Craft Wire Bracelet
Designer Kristen Fagan

Materials

26ga Green Soft Flex Craft Wire
20ga Bronze Soft Flex Craft Wire
1 Strand Clasp, Toggle with Jump Rings
or Make your own clasp

Tools

5-Pin Knitting Spool
Draw Plate
Cutters
Round Nose Pliers

Instructions

I found this video by Beaducation on YouTube that made knitting with Craft Wire finally click and make sense for me. It helped me see that with craft wire you pull the wire out to the edge of your spool with your stylus, then flip the wire up and over your pin with your fingers. The tension is carried from one pin to the next - not through pulling on the tail as it is with flexible beading wire.

Step 1:
Working straight from your Soft Flex Craft Wire 26 Gauge Spool knit the wire using a 5-Pin Knitting Spool. String the wire down through the center of the knitting spool leaving about a 2" tail. Wrap the wire around your pins in the same manner as this Beaducation video minus the addition of beads.



Step 2: Once you have completed your desired length of wire knitting, cut off about 2" extra wire form the spool and carefully remove your knitted wire tube from the spool. Take the end of the wire and thread it into the last 5 open loops to secure your knitted tube. The result will be a wonky shape as shown.



Step 3: Using a draw plate, run your knitted wire tube through one of the large holes to begin smoothing out the shape. Then move to a smaller hole and so on until you are happy with the wire shapes and diameter.





Step 4: Next, you'll need to finish off your wire ends. You may choose to use a cone or bead cap or you can wire wrap your own cones as I did. To wire wrap your cones, cut a 10" piece of 20 Gauge Bronze Craft Wire (it's better to error on the side of too much length then not enough). About 1/2" from the green knitted tube end, stick one end of the bronze wire through the knitted tube and tuck it around the knitted tube to secure it. Then begin wire wrapping the tube towards the end. When you get to the end of the knitted tube, use your round nose pliers to create a loop and then wire wrapped back down the tube to where you started making sure to cover the tube entirely with wire and cut off excess. Repeat on the other side.



Step 5: At this point you can add you jump rings and clasp or you can make your own. I decided to make a simple hook clasp to finish off my bracelet. Cut 2-3" of 20 Gauge Bronze Craft Wire and straighten the wire with nylon jaw pliers.



Step 6: Using my round nose pliers I made a small loop on one end and then made a larger loop with my large bail making Wubbers pliers.Trim excess wire so it's about the same length as the little loop.



Step 7: Lastly, work harden the clasp with a nylon hammer and rubber block and attach to one end of your bracelet. Here is the finished design. I especially like to wear it layered!






Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.