Wire Wrap Napkin Rings
Designer Kristen Fagan

Materials

18ga Vintage Bronze Soft Flex Craft Wire - 40" per napkin ring
Mix of Gold Tone Tierracast Spacer Beads
Mix of Czech Glass in Brown, Green and Burgundy
Two Tone Champagne Colored 3 Cut Czech Glass Beads
Tube to wrap wire around (I used wrapping paper tube)

Tools

Nylon Jaw Pliers
Chain Nose Pliers
Cutters

Instructions



Step 1:
Cut 40" of Craft Wire. Use your nylon jaw pliers to smooth out the wire. Wrap wire around the tube 6 times.



Step 2:
Remove from the tube, take the short wire end and using your chain nose pliers wrap the wire tail around one of the loops to secure the ring.



Step 3:
Now use the long wire tail and feed it through the ring. Zig zag the wire up and down adding in two or three beads on every other pass. I found that if my wire was even slightly bent some beads had a hard time passing through. Using my nylon jaw pliers to smooth out the wire before stringing the beads helped in most cases.If you happen to run out of wire, you may easily add more by wrapping the end of a new wire piece around one of the ring wires and then continue zig zagging up and down and adding beads as you were.





Step 4: Continue until you have used most of the wire and wrap the wire end around the ring to secure.





Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.