Simple Braided Wire Snowman Ornament
Designer Sara Oehler


White Econoflex Wire .019
3x3mm Crimp Tubes - 2 pcs
4mm Crimp Covers - 2 pcs


Mighty Crimping Pliers
Chain Nose Pliers
Bead Stoppers


Step 1: Clip a bead stopper on one end of three strands of Econoflex wire and then braid the wires for 14 inches.

Step 2: Use the braid to string one crimp tube. Pass back through the tube to create a 22mm circle (top of snowman).

Step 3: Use the braid to string one crimp tube, 2 inches from the last one. Pass back through the tube to create a 48mm circle (bottom of snowman).

Step 4: Pass the braid back through the first crimp tube, creating a 30mm circle (middle of snowman).

Step 5: Crimp both crimp tubes and cover with crimp covers. Hold the circles as straight as possible when you crimp. Trim excess wire. Click here for crimping instructions.

Step 6: Add a ribbon for a scarf and an ornament hanger. Find directions for creating an ornament hanger here. Please note that this ornament is unlikely to lay completely flat. If you find that the loops are not as flat as you like, fold them in the opposite direction until they straighten out more.

Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.