Beaded and Wire Snow Angel Ornament
Designer Sara Oehler


20ga Non-Tarnish Silver Plated Soft Flex Craft Wire
8mm Clear Crystal Bead
2 Clear Dichroic Glass Beads


Round Nose Pliers
Chain Nose Pliers
Nylon Jaw Pliers


Step 1: Using about 15 inches of craft wire, create a wire wrap loop on one end.

Step 2: String the smallest bead first, the middle sized bead next and the largest bead last. Bend the wire at the bottom.

Step 3: Wrap the wire around the bottom bead and the base of the wire once.

Step 4: Make a wide loop for your first angel wing. Wrap the wire around the base of the wire.

Step 5: Make a matching wide loop on the other side for the second wing. Wrap the wire around the base of the wire. Trim excess wire.

Step 6: Create an ornament hanger. Don't forget to work harden that hanger! Find directions for creating an ornament hanger here.

Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.