Earthenwood Inspired Bracelet
Designer Sara Oehler

Materials

Turquoise Soft Flex Wire Beading Wire .019 diameter
Earthenwood Toggle from Earthenwood Studio - 1 set
Jump Rings - 6 pcs
2x2mm Copper Crimp Tubes - 6 pcs
3mm Copper Crimp Covers - 6 pcs
Turquoise Nuggets - 2 pcs
Earthenwood Red Connectors from Earthenwood Studio - 2 pcs
Earthenwood Wing Connector from Earthenwood Studio - 1 pc

Tools

Cutters
Crimping Pliers
Chain Nose Pliers

Instructions

Step 1: Attach 3 jump rings to the toggle bar, 1 jump ring to the toggle, 1 jump ring to each of the red connectors.

Step 2: Use 4" of wire to string 1 crimp tube and the jump ring attached to the toggle. Pass back through the tube and crimp. Use the wire to string 1 turquoise bead, 1 crimp tube and the jump ring on a red connector. Pass back through the tube and crimp. Cover both tubes with crimp covers.

Step 3: Use 4" of wire to string 1 crimp tube and center it. On one side of the tube, string the second half of the red connector used in Step 2 and pass back through the tube. On the other side, string the wing connector and pass back through the tube. Crimp and cover the tube with a crimp cover.

Step 4: Repeat Step 3, attaching a new red connector.

Step 5: Repeat Step 2, attaching to the toggle bar.


Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.