Braided Flower Ring
Designer Jamie Hogsett

Skill Level Beginner


Three colors of Soft Flex Beading Wire .019 diameter - 7" of each color
3x3mm Sterling Silver Crimp Tubes - 1 pc
5mm Silver-Plated Pewter Flower Bead - 1 pc


Mighty Crimpers
Bead Stoppers


Step 1: Use all three wires to string the flower bead to the center of the wires. Attach one Bead Stopper to the wires on one side of the flower bead. Hold the wires on the other side of the flower bead and braid them together. Use all three wires to string the crimp tube. Place a Bead Stopper on the ends of the wires.

Step 2: Remove the first Bead Stopper. Braid the three wires together. Use all three wires to pass through the crimp tube in the opposite direction as the other wire ends. Place the Bead Stopper back on the wire ends.

Step 3: Place the ring on the desired finger and adjust both ends of the wires to size. Make the ring slightly larger than the desired finished size as it will shrink slightly when crimped. Remove the ring from the finger and crimp. Remove Bead Stoppers. Trim wire ends.

Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.