Chocolate Sampler Bracelet
Designer Jamie Hogsett

Skill Level Beginner

Materials

925 Sterling Silver .019 Soft Flex Extreme Beading Wire - 22 inches
Red Jasper .019 Soft Flex Beading Wire - 11 inches
Chrysoprase .019 Soft Flex Beading Wire - 11 inches
21x10mm Sterling Silver Round Magnetic Clasp - 1 set
2mm x 2mm Sterling Silver Crimp Tubes - 2 pcs
3mm x 3mm Sterling Silver Crimp Tubes - 2 pcs
3mm Sterling Silver Crimp Covers - 2 pcs
4mm Sterling Silver Crimp Covers - 2 pcs
18x15mm Cirrus Green Shale Kazuri Beads - 3 pcs
16mm Orange Tagua Nut 2-Hole Flower Connectors - 2 pcs
22x17mm Dark Brown Tagua Nut 2-Hole Open Connectors - 2 pcs

Tools

Cutters
Mighty Crimpers
Regular Crimping Pliers
Kazuri beads and Tagua Nut connectors from Antelope Beads.

Instructions

Finished Size: 7 1/4"


Step 1: Use all four wires to string one 3mm x 3mm crimp tube. Place the tube about 2" from the wire ends, and crimp. Trim both Silver wire tail ends and the Red Jasper wire tail end. Cover the crimp tube with one 4mm crimp cover. Use the remaining Chrysoprase wire tail end to string one 2mm x 2mm crimp tube and one half of the clasp. Pass back through the tube and crimp. Cover the crimp with one 3mm crimp cover. Use all four wires to string one Kazuri bead.

Step 2: Use one Silver wire (Silver wire A) and the Chrysoprase wire to string the left hole of 1 flower connector. Use the other Silver wire (Silver wire B) and the Red Jasper wire to string the right hole of the flower connector. Adjust the flower connector so that there is about 1/4" of exposed wire between the Kazuri bead and the flower connector.

Step 3: Use Silver wire A and the Red Jasper wire to string the first right hole of 1 open connector. Use Silver wire B and the Chrysoprase wire to string the first left hole of the open connector. (The two silver wires should cross between the flower connector and the open connector.)

Step 4: Use Silver wire B and the Red Jasper wire to string the second left hole of the open connector. Use Silver wire A and the Chrysoprase wire to string the second right hole of the open connector. Adjust the open connector so that there is about 1/4" of exposed wire between the flower connector and the open connector.

Step 5: Use all four wires to string 1 Kazuri bead. Adjust the bead so that there is about 1/4" of exposed wire between the open connector and the Kazuri bead.

Step 6: Repeat Steps 2-5 once.

Step 7: Use all four wires to string one 3mm x 3mm crimp tube to the Kazuri bead, and crimp. Trim both Silver wire tail ends and the Chrysoprase wire tail end. Cover the crimp tube with one 4mm crimp cover. Use the remaining Red Jasper wire tail end to string one 2mm x 2mm crimp tube and one half of the clasp. Pass back through the tube and crimp. Cover the crimp with one 3mm crimp cover.




Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.