Knitted Turquoise Cuff
Designer Jamie Hogsett

Skill Level Intermediate


Fluorite Soft Flex Beading Wire .019 diameter
Red Jasper Soft Flex Beading Wire .019 diameter
Citrine Soft Flex Beading Wire .019 diameter
21mm Sterling Silver Square Toggle Clasp from Springall Adventures - 1 set
14mm x 18mm Sterling Silver Cone from Springall Adventures - 2 pcs
3x3mm Sterling Silver Crimp Tubes - 2 pcs
5mm x 3mm Turquoise Rondelles - 1 strand


3-Pin Knitting Spool and Stylus
Mighty Crimping Pliers


Finished Size: 8 1/4"

Step 1: Without cutting any wire from the spool, use the Red Jasper wire to string the entire strand of turquoise rondelles.

Step 2: Without cutting any wire from the spools, use all three wires and the Knitting Spool to knit a 7" length of knitted wire using Style 1 in the instructions for How to Use the Knitting Spool, making sure to leave 3" of wire at the beginning of the knitted wire and moving 1 turquoise rondelle up and between pegs for every other stitch. Cut the wire from the spool, leaving a 3" tail. Set aside.

Step 3: Use all three wires on one end of the knitted piece to string 1 cone, 1 crimp tube, and one half of the clasp. Pass back through the tube, snug the beads making sure the cone covers the end of the knitted wire, and crimp. Trim the wire ends.

Step 4: Repeat Step 3 for the other end of the bracelet.

Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.