Kyanite Wings Earrings
Designer Jamie Hogsett

Skill Level Beginner

Materials

925 Silver Extreme Flex Wire .019 - 12"
34x19mm Sterling Silver Flower Skirt Bead Frame - 2 pcs
Sterling Silver Ear Wires - 1 pcs
2mm x 2mm Sterling Silver Crimp Tubes - 4 pcs
3mm Sterling Silver Crimp Covers - 4 pcs
7x5mm Kyanite Tubes - 6 pcs

Tools

Cutters
Crimping Pliers

Instructions

Finished Size: 2 3/8"


Step 1: Use 6" of wire to string 1 kyanite tube, the first hole of 1 bead frame, 1 kyanite tube, the second hole of 1 bead frame, and 1 kyanite tube.

Step 2: Use both ends of the wire to string 1 crimp tube. Adjust the wires so that one end is about two inches longer than the other end. Place the crimp tube so that there is about 1/4" of wire between the crimp tube and the kyanite tubes, and crimp. Do not cut the longer length of wire. Trim the short wire. Cover the tube with a crimp cover.

Step 3: Use the remaining wire to string 1 crimp tube and 1 ear wire. Pass back through the tube, leaving a small loop of wire around the ear wire, and crimp. Cover the tube with a crimp cover.

Step 4: Repeat Steps 1-3 for the second earring.




Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.