Golden Rings Earrings
Designer Jamie Hogsett
Skill Level Beginner

Materials

24K Gold Plated Soft Flex Extreme Wire .014 diameter - 36"
2x2mm Gold Filled Crimp Tubes - 18 pcs
5mm Gold Filled Soldered Jump Rings - 6 pcs
14K Gold Ear Wires - 1 pair

Tools

Cutters
Crimping Pliers

Instructions

Step 1: Cut the beading wire into eighteen 2" piece.

Step 2: Use one 2" wire to string 1 crimp tube and 1 jump ring. Pass through the crimp tube again, forming an 8mm circle of wire, and crimp. Repeat to attach a second wire and crimp tube to the same jump ring.

Step 3: Repeat Step 2 twice for a total of three sets of wire circles on a jump ring.

Step 4: Use one 2" wire to string 1 crimp tube and 2 of the jump rings from Steps 2 and 3. Pass through the crimp tube again, forming a 10mm circle of wire, and crimp.

Step 5: Use one 2" wire to string 1 crimp tube, the second jump ring used in Step 4, and the remaining jump ring from Steps 2 and 3. Pass through the crimp tube again, forming a 10mm circle of wire, and crimp.

Step 6: Use one 2' wire to string 1 crimp tube and the previous jump ring. Pass back through the tube again, forming a 10mm circle of wire, and crimp.

Step 7: Attach 1 ear wire to the jump ring used in Step 2.

Step 8: Repeat Steps 1 to 7 for the second earring.

Step 9: Adjust the wire circles so that the 10mm wire circles are between the 8mm wire circles.


Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.