Econo Beaded Cell Phone Charm
Designer Sara Oehler

Skill Level Beginner

Materials

Econoflex Wire, .014 Diameter - 6 inches
Cell phone attachment
2mm x 2mm Sterling Silver Crimp Tubes - 5 pcs
3mm beads

Tools

Regular Crimping Pliers
Cutters

Instructions



Step 1: Cut the wire into two 3" pieces.( I used 2 different colors of wire, you can mix and match using the 7 colors of Econoflex.

Step 2: Use both wires to string the ring on cell phone charm to the center of the wires. Use all four ends of wire to string 1 crimp tube. Slide the crimp up to the ring, and crimp.

Step 3: Trim the wire to 4 different lengths: 1/2",1",1 1/4",1 1/2".

Step 4: Use the 1/2" wire to string 1 to 3 beads and 1 crimp tube. Crimp the tube at the very of the wire.

Step 5: Use the 1" wire to string 1 to 3 beads and 1 crimp tube. Crimp the tube at the very end of the wire.

Step 6: Use the 1 1/4" wire to string 1 to 3 beads and 1 crimp tube. Crimp the tube at the very end of the wire.

Step 7: Use the 1 1/2" wire to string 1 to 3 beads and 1 crimp tube. Crimp the tube at the very end of the wire.


Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.