Extreme Silver Wrap Bracelet/Necklace
Designer Jamie Hogsett
Skill Level Beginner

Materials

925 Sterling Silver Plated Soft Flex Extreme Wire .014 diameter - 72"
925 Sterling Silver Plated Soft Flex Extreme Wire .019 diameter - 48"
925 Sterling Silver Plated Soft Flex Extreme Wire .024 diameter - 24"
3x3mm Sterling Silver Crimp Tubes - 2 pcs
9mm x 6mm Round Sterling Silver Charm with Austrian Crystals in Olivine - 10 pcs
16mm Sterling Silver Toggle Clasp with Austrian Crystals in Olivine - 1 set

Tools

Cutters
Mighty Crimping Pliers
Bead Stoppers
Tape

Instructions

Finished Size: 19 3/4"

Step 1:
Cut the .019 diameter wire into two 24” pieces and the .014 diameter wire into three 24” pieces.

Step 2: Use all six strands of wire to string 1 crimp tube and the ring half of the clasp. Pass back through the tube and crimp.

Step 3: Use the .024 diameter wire to string all ten charms. Attach a Bead Stopper to the end of the wire.

Step 4: Tape the ring half of the clasp to your work surface. Separate the wires into three groups, based on wire diameter.

Step 5: Braid the three groups of wire for about 2". Slide 1 charm up to the base of the braid. Braid the three groups of wire for about 1". Slide 1 charm up to the base of the braid.



Step 6: Repeat Step 5 four times.

Step 7: Braid the three groups of wire for about 2 1/2". Place a Bead Stopper on the braid about 1/4" from the end of the braid.

Step 8: Use all six wires to string 1 crimp tube and the bar half of the clasp. Slide the tube so that it is right at the side of the Bead Stopper. Pass all the wires back through the tube. Remove the Bead Stopper and adjust the tube if necessary. Crimp the tube and trim excess wire.



Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.