Very Fine Design in White
Designed by: Sara Oehler
Skill Level: Beginner

Materials:

Tools:

Instructions:

  1. Cut the Soft Touch™ Wire, .010 diameter, into two 1 1/4" pieces, two 1 1/2" pieces, two 1 3/4" pieces, and one 2" piece.

  2. Use the 2" wire to string 1 crimp tube. Pass back through the tube, forming a loop large enough to fit over the .019 diameter wire. Repeat with all of the remaining .010 diameter wire pieces.

  3. Use the 2" wire to string about 6 Delicas, 3 accent beads, about 4 Delicas, 3 accent beads, and one 1mm x 1mm crimp tube. Snug the beads, crimp the tube, and trim any excess wire. Repeat with each of the remaining pieces of .010 diameter wire, using accent beads and Delicas to give each pair of wires a different pattern.

  4. Attach one Bead Stopper to one end of the .019 diameter Soft Flex® Wire. String about 5 Delicas, the loop of one 1 1/4" wire, 1 Delica, the loop of one 1 1/2" wire, 1 Delica, the loop of one 1 3/4" wire, 1 Delica, the loop of the 2" wire, 1 Delica, the loop of one 1 3/4" wire, 1 Delica, the loop of one 1 1/2" wire, 1 Delica, the loop of one 1 1/4" wire, and about 5 Delicas.

  5. String one 2mm x 2mm crimp tube and one half of the clasp. Pass back through the tube and crimp. Remove the Bead Stopper and attach the other end of the wire to the other half of the clasp, making sure to adjust the wire so that the necklace is just longer than a choker, falling on your collarbone.

Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.