Golden Flourite Necklace
Designed by: Virginia Magdaleno
Skill Level: Beginner

Materials:

• Soft Touch™ Wire, .019 Diameter - 1 spool
• 18k Gold Plated Toggle - 1 toggle
• 2mmx 2mm Gold Filled Crimp Tubes - 12 crimps
• 6mm Gold Plated Finish Tanzanite Squardelles - 6 beads
• Head Pins-2 Inch-20 Guage Gold filled - 6 head pins
• Large Emerald Cut Fluorite - 3 beads
• Faceted Fluorite Rounds - 74 beads

Tools:

• Soft Flex® Round Nose Pliers
• Soft Flex® Needle Nose Pliers
• Soft Flex® Flush Cutters

Instructions:

1. Use 1 Head Pin to string 1 Round Flourite and form a wire wrapped loop 1 1/2 inches from the top of the bead. Use 1 Head Pin to string 1 Round Flourite and form a wire wrapped loop 1 inch from the top of the bead. Use 1 Head Pin to string 1 Round Flourite and form a wire wrapped loop 1/2 inch from the top of the bead. Repeat entire step for a second set of dangles.
2. Use Soft Flex® Flush Cutters to cut 17 inches of Soft Touch Wire. Please note: Adjust length of wire according to neck size. Seventeen inches will accommodate a very small neck.
3. String one 2x2mm crimp tube and one half of the clasp. Pass back through the tube and secure using your Regular Crimping Pliers. Use Flush Cutters to trim excess wire.
4. String 5 Round Flourite, 1 Crimp Tube, 7 Round Flourite, 1 Crimp Tube, 4 Round Flourite, 1 Squaredelle, 4 Round Flourite, 1 Crimp Tube, 5 Round Flourite, 1 Crimp Tube, 1 Emerald Cut Flourite, 1 long dangle, 1 medium dangle, 1 short dangle, 1 Round Flourite, and 1 Squaredelle.
5. String 1 Emerald Cut Flourite.
6. Repeat Step 4, reversing the stringing sequence. Repeat Step 3, attaching the wire to the other half of the clasp.

Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.