CZ Chain Earrings
Designer Virginia Magdaleno
Skill Level Intermediate

Materials

26 gauge Non-Tarnish Silver Plated Soft Flex Craft Wire - 1 spool
Sterling Silver 4 Loop Open Faced Connector - 2 pcs
Sterling Silver Ear Wires - 1 pair
CZ Rondelle Beads - approx. 66 pcs

Tools

Cutters
Needle Nose Pliers
Round Nose Pliers

Instructions

Step 1: Attach 1 ear wire to the top outside loop of 1 connector

Step 2: Use Soft Flex® Professional Flush Cutters to cut 4 inches of wire. Form a wire wrapped loop that attaches to the top inside loop of the connector. String 3 CZ Rondelles. Wrap the wire up and around the Rondelles and once around the wire above them. Trim excess wire.

Step 3: Use 2 inches of wire to form a wire wrapped loop that attaches to the bottom middle loop of the connector. String 1 CZ Rondelle and form a wire wrapped loop. Use 5 inches of wire to form a wire wrapped loop that attaches to the previous wire wrapped loop. String 5 CZ Rondelles. Wrap the wire up and around the Rondelles and once around the wire above them. Trim excess wire.

Step 4: Use 2 inches of wire to form a wire wrapped loop that attaches to the bottom left of the connector. String 1 CZ Rondelle and form a wire wrapped loop.

Step 5: Use 2 inches of wire to form a wire wrapped loop that attaches to the previous look. String 1 CZ Rondelle and form a wire wrapped loop.

Step 6: Repeat Step 5 eleven times.

Step 7: Repeat Step 5, attaching the final wire wrapped loop to the bottom right of the connector.

Step 8: Repeat Step 4. Repeat Step 5 eight times. Repeat Step 7.

Step 9: Repeat Steps 1-8 to make a second earring.


Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.