American Pride Bracelet
Designer Shelley Carlson
Skill Level Beginner

Materials

Satin Silver Soft Flex Beading Wire .024 diameter - 7" to 8"
2x2mm Sterling Silver Crimp Tubes - 2 pcs
Red, White & Blue Furnace Beads - 17 pcs
5mm Round Sterling Silver Beads - 18 pcs
12mm Sterling Silver Toggle - 1 set

Tools

Crimping Pliers
Cutters

Instructions

Step 1: Cut approximately 7" or 8" of Soft Flex® .019 wire from the spool. String one sterling silver crimp tube, then one side of your toggle, and then put the wire back through the crimp. Secure using crimping pliers. Cut off excess wire using Flush Cutters.

Step 2: String beads in the following order: Sterling Silver Round Bead, Red Furnace Glass Bead, Sterling Silver Round Bead, White Furnace Beads, Sterling Silver Round Bead, Blue Furnace Glass Bead. Continue stringing in that order until desired length of bracelet is achieved, ending the design with a Sterling Silver Round Bead.

Step 3: String 1 sterling silver crimp tube on wire, through the other end of the toggle, then back through the crimp. Pull the wire tight, but with enough slack for wire to move around using bent nose pliers. Secure crimp using crimping pliers. Cut off excess wire using Flush Cutters.


Projects not intended for children under the age of 13. The information on this instruction sheet is presented in good faith, but no warranty is given, nor results guaranteed. Soft Flex® Company disclaims all liability from any injury to anyone undertaking the construction of this project as a result of improper safety precautions.